Eltako FTS14KS FTS14 communication tools.

Communication interface FTS14 communication interface for the Eltako-RS485-Bus with integrated switching power supply 12 V DC-1A, stand-by-loss only 0.6 Watt, series installation device for mounting on support rail DIN-EN 60715 TH35, 2 division units, cross wiring bus and power supply with plug-in bridge, mini-USB for connecting a PC for creating a device list, for configuring actuators with the help of PCT14 and for data backup TLE14 Eltako-RS485 bus with integrated power supply 12V DC/8W. Stand-by loss only 0.6 Watt. Supply voltage 230V. Included are 2 terminal resistors for plugging in with imprint ?, 1/2 TE, 3 plug-in bridges 1 TE (including 1 replacement), 2 plug-in bridges 1/2 TE (including 1 replacement) and a plug-in bridge mounting tool SMW14. Bus and power supply with plug-in bridge. At the last actuator, the adjacent second terminal resistor must be plugged on. Mini USB to connect a PC to create a device list, to configure the actuators using PCT14 and to backup data. A legalization code for downloading the PCT14 from the Eltako-Homepage www.eltako.de is the FTS14KS. All FTS14EM and possibly gateways FGW14 are connected to the terminal hold when they connect a PC to RS232 bus. 10 different operating modes according to the user manual can be set with the operating mode rotary switch BA. The LED at the bottom lights green when a connection was established by PCT14. When reading or writing data, the green LED flickers. The green LED expires when the connection was separated from PCT14. With a load greater than 50% of the rated power of 8W, half of the division unit is required with the spacer DS14 on the left side.